Setup/Recommended Settings for Fluffyrock Unleashed
Quick guide to setting up Fluffyrock Unleashed in Windows 10. Most of these are drhead's recommendations, not mine, so all credit to them. I'm just summarizing everything for easy reference.
Install Automatic1111 and switch to the dev branch
If you installed Automatic1111 with git, you can skip this step. If you didn't, I don't think you can use the dev branch. You'll need to go to the Automatic1111 repository and do a new install using the Automatic Installation on Windows instructions.
If you installed Automatic1111 using git:
Go to the main Automatic1111 directory
Type cmd in the address bar
In the window that pops up, type git checkout dev
After entering that type git pull
Download Fluffyrock Unleashed (base and refiner) and make sure to download the config file as well and put it in the same folder as the models.
Download the Furception VAE
(Optional) Download Boring_e621 negative embedding
(Optional) Download Fluffyrock Quality Tags
Load up Automatic1111
Switch to Zero Terminal SNR noise schedule: Settings -> Sampler Parameters -> Noise schedule for sampling -> Zero Terminal SNR
Install the CFG Rescale extension by going to the Extensions tab -> Install from URL and pasting in the URL. The recommended setting for the extension is 0.7
(Optional) Install the FreeU extension. The recommended settings are:
Transition Smoothness: 1
Backbone 1 Scale: 1.5
Skip 1 Scale: 0.8
Backbone 2 Scale: 1.6
Skip 2 Scale: 0.8
Everything else default
(Optional) Install the Self Attention Guidance extension and leave the settings at default
Generation settings
For the refiner, Switch at 0.8 is recommended
Can only use e621 tags with this model
Recommended sampler: DPM++ 2M Karras
Recommended resolutions: 768-1088