Stable_Yogi I don't know exactly what your files do, but they ruin the quality of the generation (a lot). I noticed when comparing the metadata of the image generated before inserting and using your files with the same image generated afterwards that the image generated after inserting your files (in addition to being worse) had a difference in the metadata. The difference was that the metadata of the next generation indicated "Token merging ratio" values of 0.7. I had never changed those values in my SD settings, and it was strange that they appeared in the metadata parameters of the second image. This metadata of the next image should have been the same as the image before inserting your files... but that wasn't the case... your files changed something. I went into the SD settings to change/reset the "Token merging ratio" value from 0.7 to 0 and tried regenerating the same image, but what happened was that the image quality didn't improve, but there were no references to "Token merging ratio" in the image's metadata. I tried changing other settings and running other tests, but nothing helped... each generation was worse than the ones generated before I inserted and used your files. I'm sure the problem is caused by your files because after my first SD became unusable, I deleted it and created a second SD clean folder... I tested that too, and it worked fine until I inserted and used your files...