IMPORTANT: INFORM ALL WAN USERS! I DISCOVERED HOW TO USE LORAS 'NSFW/SFW' IN WAN 2.2 T2V, GETTING THE FULL POTENTIAL OF "HIGH NOISE" AND "LOW NOISE." THE RESULTS WERE IMPRESSIVE!! I ran it on an RTX 3060 6GB, 32MB RAM, 480x480, length: 41, generation time: 5 minutes to generate each video. The quality is fantastic! For those of you with more powerful computers, the results will be even more incredible. I used the models: WAN 2.2 - Q4_1.gguf FOLLOW THE STEPS BELOW: 1: Don't use acceleration/enhancement LoRas (such as Lightx2v or other) on "high noise"; use only on "low noise" with strength 1. (I'm using this version of Lightx2v LoRa): lightx2v_T2V_14B_cfg_step_distill_v2_lora_rank64_bf16 2: Use 'NSFW/SFW' LoRas on both "high noise" and "low noise" models. On "high noise," use strength 2, and on "low noise," use half the strength, with strength 1. You can vary the strengths as you like, but always keep the "low noise" strength at half the strength of the "high noise." 3: Use these settings in KSamplers: "high noise": steps: 9 / cfg: 3.5 / euler/simple / start_at_step: 0 / end_at_step: 1 "low noise": steps: 9 / cfg: 1.0 / euler/simple / start_at_step: 1 / end_at_step: 10000 Note: To improve speed, I set the Windows system to "best performance," disable unnecessary background programs and applications, and lower the desktop resolution. This significantly speeds up video generation. I hope this helps.