画風違うので既存（A型）とは別版に

正直ほとんど既存のと変わらないと言えば変わらないが…

以下部分特徴を調整
・小指の隙間を開けないように（高強度適用時/0.7↑ で小指隙間をほぼ開かなくなる）
・頭部への手の位置部分を調整。頭部面、斜め上箇所ーーバニーコスプレでのウサギ耳が付いてる辺りのやや下位置に。空間を開けず配置
・手の斜め角度

■推奨適用強度
IL：0.7- 全身描写時はAdetailer推奨
Anima：0.6- 全身描写をしたい時は解像度をかなり縦長に
0.7↑ で うさ耳が出にくくなるかなと思う（Anima側）
0.6↓ で 小指が少し離れるタグで出やすい rabbit pose の形に近づく（IL）

Since the art style differs, this is a separate version from the original (Type A).

To be honest, it isn't drastically different from the original...

Adjustments made to the following details:

・Prevented a gap at the little finger (when using high strength—0.7 or higher—the gap virtually disappears).

・Adjusted the hand placement relative to the head. Positioned it against the head surface, slightly below the area where the rabbit ears would be on a bunny costume—ensuring there is no gap between the hand and the head.

・Adjusted the diagonal angle of the hand.

■ Recommended Strength

IL: 0.7+ (ADetailer recommended for full-body shots)

Anima: 0.6+ (Use a tall aspect ratio if aiming for full-body shots)
I think the bunny ears might be less likely to appear at 0.7 or higher (on the Anima side).
At 0.6↓, the little finger separates slightly, bringing the pose closer to the "rabbit pose" (IL).