Ever wanted to know what a ?????? looks like? Ever wondered what it would be like to see a character inside a female appendage? Look no further than this model! Vore? You got it (sans the teeth, just the insides)! Unbirthing? You got it! Caves with walls of flesh like the ones frequently depicted in Sci-Fi, anime and some of those tacky 1980s shows... (admittedly, I liked them too...)? You got it!

This model is very good at depicting the insides of a person. The only issue? It has a slight contrast problem... So it pairs well with some of your upscalers (which add too much contrast). Come download this model today.

$5.99 +S&H while supplies last...

(Not really, the model is free to download.)

This model works a little differently than other LoRAs.

⮊ The strength indicator is going to strongly influence how the end image turns out.

⯄ Use low strengths (0.1-0.3) for when you want bodily insides (??????, ????, arteries, etc.) to look a bit more... good looking.

⯄ Use mid strengths (0.4-0.7) for when you want to add fleshy walls and/or want a more pink-looking image

⯄ Use high strengths (between 0.8-0.9) if the model is uncooperative with the LoRA. You can also use "the ring" trigger word with this (or any lower strength) to make the LoRA do its charm.

⯄ Use ultra high strengths (0.9-1) if you want to produce an image of a ?????? or another internal organ. At these strengths the model is disobedient. It might produce what you want, but it is more likely that it does not actually generate what you want it to generate.

⮊ This model does not need the trigger words. Most of the time it works without the trigger words. Add the trigger words for extra strength if needed (or if you want the image to include an all-seeing cervix).

⯄ P.S.: I strongly suggest you use "in between" and "non-conventional" numbers (like, lets say... 0.874, or 0.626 or 0.543). Use any number in between that will yield the desired image. The key is in the number and the strategic use of the trigger words "the ring".